[TR] TR3A SU H6 Carb Rebuild Question

[Cliff Hansen]

That’s 1-1/2 turns not 1-1/2 flats. Units matter - ask the Mars Climate Orbiter :)

Get Outlook for iOS<https://aka.ms/o0ukef>

________________________________
From: 32032021020n behalf of
Sent: Saturday, September 8, 2018 2:05 AM
To: Jim Henningsen
Cc: Triumphs
Subject: Re: [TR] TR3A SU H6 Carb Rebuild Question

I have heard 1-1/2 to 2, I always start at 1-1/2 with no problems.

Speaking of SU, I can pick up a full catalog while at the factory booth today or tomorrow if anyone would like one. Just the cost of mailing after I get back to the states. Supplies limited to what I can carry off.

Bill B
TS30800L

Sent from my Handspring Treo

On Sep 8, 2018, at 1:28 AM, Jim Henningsen <trguy75 at gmail.com> wrote:

Having a spot of fun learning to rebuild my SU carbs. Got them all back
together with new kits and looking very nice indeed. Throttle shaft wear
felt very minimal so I did not replace. Kit included new needle and float
valves along with gaskets. First time doing a set of SUs so please bear
with me. My question is where should the jet adjusting nut be set prior to
running and setting mixture? I had hear one and half flats backed off from
fully tightened position? Thoughts would be greatly appreciated as I would
like to test and adjust this weekend.
Cheers,
Jim Henningsen
Ocala FL
61 TR3A
62 TR4
75 TR6
82 Jeep CJ8
02 Triumph Trophy 1200 (Had to have it)

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/wbeech@flash.net

** triumphs at autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/cliff_hansen@outlook.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20180908/92c5c872/attachment.html>