[TR] TR3 Caliper seal

[Peter Caldwell]

I have a pair of those seals NOS in stock.  But you should NEVER have to 
use them to rebuild those calipers. we've done many, many.

Peter C


On 5/22/2017 6:48 PM, Randall wrote:
>> But that said - there is no 'cap' to be removed to get at the pistons -
> I could be wrong, but I think he has the earlier TR3/A style calipers, with
> the cross-over tube.  They have a big plug in one side, which Girling said
> to never remove.  Under that plug, there is another plate and then there is
> a round flat gasket between the plate and the caliper body.
>
> We went through this last year, but I don't recall the resolution and can't
> find the thread.  There was a place in the UK that sells those gaskets for
> other sizes of Girling calipers, but I don't know if anyone found a size to
> fit the TR3 version.  The SPC lists the gasket (aka "ring, sealing end
> plug") as P/N 504829.
>
> Someone suggested using an O-ring, but I'm dubious about that solution.  To
> seal high pressures, O-rings have to go into a groove that supports most of
> the ring; and there is no groove for them in the caliper.  And the pressure
> there can go over 1000 psi (during a panic stop).
>
> -- Randall
>
>
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/peter@nosimport.com

-- 
Peter Caldwell
World Wide Auto Parts of Madison WI
2517 Seiferth Rd
Madison  WI  53716
(608)223-9400
www.nosimport.com
http://stores.ebay.com/worldwideimportautoparts

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20170523/957d1ca9/attachment.html>