[TR] Overdrive issues
ptegler
ptegler at verizon.net
Sat Jun 11 07:15:22 MDT 2016
the bypass valve spring can be replaced/shimmed to adjust pressure as
needed.
ptegler
On 6/10/2016 9:04 PM, hdrider570 at att.net wrote:
> When I had this problem with a J type OD, it was wear in the pump
> piston/bore. This pump uses no seals so I expect that your mechanics
> are talking about the accumulator piston(s). Basically when the
> piston/bore wears the clearances increase which allows oil to bypass
> the piston resulting in lower pressure. One thing that I noticed was
> that the slippage was more pronounced once the OD warmed up thus
> reducing the viscosity of the oil.
>
> I expect that a worn drive pin in the piston could cause a similar
> problem by shortening the piston sweep.
>
> Bottom line is if you are not getting enough oil pressure, it is a
> hydraulic problem which is either not enough supply (pump wear?) or
> excessive losses somewhere such as bad piston seals etc.
>
> Edward Hamer
> Petaluma CA
>
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/ptegler@verizon.net
--
Paul Tegler ptegler at verizon.net www.teglerizer.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20160611/a6dbac16/attachment.html>
More information about the Triumphs
mailing list