[TR] TR3A flywheel bolt on ring gear
William Brewer
billbrewer59 at yahoo.com
Thu Feb 18 12:56:31 MST 2016
Hi Terry, Once I took my rusty TR3A starter apart and cleans everything up and lubed it. I put it in the car and the starter just whirred away without cranking the engine. ISTR that I pulled the starter and discovered that I had installed something in the wrong order on the starter shaft and the starter gear didn't pop out and engage. I put it back together right and it worked fine afterwards. Did you take apart your starter while it was out?
-Bill Brewer Tehachapi, CA
Question: were there different gear ratios on the ring gear? Reason I ask, while I had the OD tranny out, I replaced the flywheel with a freshly machined one. It had a somewhat better condition ring gear already bolted on. I don't know the year of production of the replacement flywheel. Bolted the same starter back in, but when I try to start the engine, the starter clicks and whirrs, but doesn't engage. Jumped it with a good battery, seems to be a strong electrical current going in. Engine turns freely by hand even with the spark plugs still in.
Thoughts?
Terry Smith, '59 TR3A TS 58667
New Hampshire where in a two day period it went from minus 20 degrees to in the 50's. Gotta love New England!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20160218/bf911858/attachment.html>
More information about the Triumphs
mailing list