[TR] Success

[Dean Tetterton]

I had those two bolts come loose on the TR4 race car. one came out and caught the flywheel and bent as it was pulled out. Banged around until ejected out the cover plate. Those now have red loctite on them.

Dean T.  


On Aug 21, 2016, at 10:56 PM, anabil007 wrote:

> There are two 1 1/2 inch Allen screws holding the adaptor mounting plate to the body of the starter. They are 180 degrees apart. Some how the lower one on the TR3 was gone!
> After we wrestled the starter out (you have to remove the carbs), cleaned everything up and installed new Allen screws they were a little longer, dremeled the body to make a flat space for locking nuts, those screws are not going anywhere, now came the hard part, getting it back in the car, new grade eight bolts and locking nuts.
> We wanted to have the nuts on the engine side, so we had to improvise a way to get them positioned, magnets, bailing wire, and luck got them how we wanted.
> Buttoned everything up, reinstalled carbs ... Every thing is good ... For now.
> Hope to see you folks at Triumphest.
> 
> Be Well
> Bill Pugh
> Wallace, CA
> 
> 
> 
> ** triumphs at autox.team.net **
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/tr3a58@verizon.net