[TR] TR3A Grab Handle Screws

[CFMTR3A]

Argh,,,,  guess I need to go survey the situation a bit more...
Thanks
Carl


-----Original Message-----
From: Randall [mailto:TR3driver at ca.rr.com] 
Sent: Thursday, October 22, 2015 8:37 AM
To: cfmtr3a at verizon.net; 'list Triumph' <triumphs at autox.team.net>
Subject: RE: [TR] TR3A Grab Handle Screws


> Does anyone know the size/type of the screw used to mount the grab 
> handle on
> TS81802 ?   The Parts Manual appears to have only the pre-60k 
> because there
> is no way to get a Simmonds fix nut (speed nut) behind it.   

On the post-60K body I parted out, there were slots in the sheet metal on
the bottom of the rail which gave just enough room to slide the fix nuts
into place.  (Had kind of a hard time getting them back out.)  So I believe
the YJ2526 screw shown in the later SPC is correct for post-60K.

But that was a long time ago, so I could be wrong.
Randall

--
I am using the free version of SPAMfighter.
SPAMfighter has removed 636 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len

Do you have a slow PC? Try a Free scan
http://www.spamfighter.com/SLOW-PCfighter?cid=sigen