[TR] TR250 emergency flashers
Roger Elliott
elliottr at rmi.net
Sat Feb 22 10:52:47 MST 2014
Thanks everyone for the suggestions and information. I did double check
the wire, there is no continuity between the purple and red wire at the
hazard relay and the hazard flasher. So, I guess I will need to bite
the bullet and dig into the wiring harness.
Roger
On 02/18/2014 09:10 PM, Dave wrote:
> The red/purple wire provides the power to the relay and the flasher -
> but only when the flasher switch is in the correct position. If the
> flashers work with the jumper then the wire from the switch is good so
> all you need to do is fix the wire to the flasher. I don't know the
> relative locations of those two parts on a TR250 but on a TR6 they are
> pretty close together. It should not be too big a pain to open up the
> harness and fix the wire. However, it is more likely the problem is
> at the connection points so start there.
>
> There is a special harness tape that has no adhesive. You need a bit
> of electrical tape at each end to keep it from unraveling. Since there
> is no adhesive the wires can shift about inside the wrap which makes
> it possible to manipulate the harness and conform it to the route it
> must take. If you wrap a harness with electrical tape it will be too
> stiff for that. You can buy harness tape from British Wire.
>
> Dave
>
>
>
> -----Original Message-----
> From: Roger Elliott <elliottr at rmi.net>
> To: Triumphs <Triumphs at autox.team.net>
> Sent: Tue, Feb 18, 2014 6:41 pm
> Subject: [TR] TR250 emergency flashers
>
>
> Hi,
>
> The emergency flashers on my wife's TR250 don't work. I was looking at
> the wiring diagram.
>
> Thanks
> Roger Elliott
More information about the Triumphs
mailing list