[TR] TR Grease Cap Removal

[William Brewer]

     I had to remove a grease cap off of the front hub on my TR6. It was
seriously on there and banged up from whoever last tried to get it off. I
ended up hitting it with a cold chisel to finally get it off. What a PITA.
   
 Is there a way to set up grease caps so you can get them off easier for next
time? I was thinking of drilling a hole through the center and mig welding a
nut on the outside so I could thread a bolt through and push against the stub
axle to push it off. Likewise, I thought about just putting a little blob of
weld on the outside of the cap so I could butt up a drift to it to tap it off
easier.
     Has anyone got any tricks to getting these grease caps off
easier?
     TIA,

     Bill in Tehachapi