[TR] TR4 front end bacing

G.D. Huggins guy at genfiniti.com
Tue Jan 29 14:13:42 MST 2013


I get it now.
I did this on my 4A.

It was a matter of welding some strengthening gussets to the chassis mounts,
and using the two-bolt brackets from a TR6.
I have descriptions and photos on my web site at:


Hope it helps.  Best of luck.

On Jan 29, 2013, at 1:49 PM, Anthony Cascio wrote:

> Sorry, it's a TR4A on a solid axle frame. And I believe it's the bracing
setup for the lower A arms where they attach to the frame.
> Evidently they were not welded as good as they could have and the single
bolt where the new kits have a two bolt set up.
> I just wondered if anyone had done this already and if there were any photos
available before I attempt this upgrade.
> Thanks
> Tony Cascio

More information about the Triumphs mailing list