[TR] TR3 Dash Vinyl Recovering - What's the best Glue to use????

[Wbeech]

I have been wondering about recovering my dash too.  The TR3B dash is covered
in some sort of sealed plastic, not vinyl like my '58 dash.  What it's the
best way to get this off?  Has anyone tried powder coating instead of the
vinyl/plastic?

Sent from mobile Bill

On Jun 24, 2012, at 8:18 AM, Dave1massey at cs.com wrote:

> I used contact adheasive.  Follow the directions and apply it to both
> surfaces and allow to dry 15 minutes or so.  A little heat helps conforming
to
> the recesses at the openings for the glove box and the center gauge panel.
> And around the rolled edges.  I also used spring loaded clamps and some
> spreader pieces there.
>
> Only after the vinyl was secure did I cut the openings for the speedo and
> tach.
>
> Dave
>
> In a message dated 6/23/2012 9:49:49 PM Central Daylight Time,
> triumph74tr6 at yahoo.com writes:
>> I'm getting ready to put new vinyl on a TR3 dash.  What is the best
>> glue to use?
>
> ** triumphs at autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net