[TR] TR6 Door Lock Barrel

lgmtr6 lgmtr6 at yahoo.com
Sun Sep 18 07:09:32 MDT 2011


Alex
The original type barrel used a clip that slid under the barrel from inside the door, and yes, it is difficult and frustrating to fit. If you are not careful you can cause distortion to the door skin when trying to push the clip in place. Unfortunately, I know this to happen all to well. But, there is a new style that is available from Moss or TRF that uses small set screws rather than the clip. I've not used it but I think it would be the way to go if I were going to replace them.

Larry Miceli
Mount Dora, Fla.
58 TR3
73 Stag
74 TR6
71 XKE OTS
87 XJ6 VDP
Sent from my Verizon Wireless BlackBerry

-----Original Message-----
From: Alex Cherington <a_flying_scotsman at yahoo.com>
Sender: triumphs-bounces at autox.team.net
Date: Sat, 17 Sep 2011 04:47:11 
To: Triumphs<Triumphs at autox.team.net>
Reply-To: Alex Cherington <a_flying_scotsman at yahoo.com>
Subject: [TR] TR6 Door Lock Barrel

Hi,
 
The door lock barrel has been getting loose and finally the whole
thing came out with the key. I haven't stripped the door yet but the clip must
have dropped out or corroded and has fallen inside.
 
Is there a better way to
fit the barrel???
 
I did this a while ago and I seem to recall it was rather
frustrating.
 
Thanks
 
Alex


triumphs at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/triumphs/lgmtr6@yahoo.com


More information about the Triumphs mailing list