[TR] Wiring loom
Dave1massey at cs.com
Dave1massey at cs.com
Tue Dec 20 14:16:03 MST 2011
In a message dated 12/20/2011 1:33:04 PM Central Standard Time,
diggle at clear.net.nz writes:
> Has anyone repaired then tested before putting their loom
> back and if yes is there a practicle way of doing it.
>
Well, not exactly but testing is pretty straight forward. Assuming you
used all the right wire colors all you have to do is use your DVM set to beep
(continuity check) and then check all the terminals with the same wire colors
and make sure they are all connected. Then move on to the next wire color.
The green, white and purple circuits will have the most terminals to
check. The blue/white and blue/red (headlight) circuits will be near the low end
of the spectrum.
If you don't have wire with the right colors do yourself and the next guy a
favour and tag the wires with some tape and permanent marker.
Good luck
Dave
More information about the Triumphs
mailing list