[TR] TR2/3 gas cap & filler assembly

[Carl TR]

ISTR that I also shortened the hose by about 1/2-3/4".  With the tank in 
place I measured the distance 'available' and the hose was too long.

Carl


----- Original Message ----- 
From: "Bob" <yellowtr at adelphia.net>
To: <triumphs at autox.team.net>
Sent: Monday, November 01, 2010 7:54 AM
Subject: Re: [TR] TR2/3 gas cap & filler assembly


> On Sunday, October 31, 2010 09:58:32 pm Angelo Graham wrote:

>> tight fit. Any tips on making the re-install easier?
> Angelo,
>
> The large hex nut does go below the deck and the cap + chrome ring go 
> above.
> As you might of guessed the cap is screwed into the hex nut.
> It is a tight fit to get the hose on the tank and the hex nut at the same
> time.
>
> I believe the last time I did this the tank was not tightened down so I 
> had
> some wiggle room. I believe I attached the hose to the hex nut/spigot 
> first
> and then eased the hose over the take inlet.
>
> Dont forget to install the clamps very loose before you put the hose on!
>
> In order to orientate the gas cap correctly, make sure you screw the cap
> tight, align, and then tighten the hose clamps.
>
> Bob
> _______________________________________________
> Triumphs at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Manage your account: 
> http://autox.team.net/mailman/options/triumphs/cfmtr3a@verizon.net