[TR] Valve cover gasket TR3
wbeech at flash.net
wbeech at flash.net
Sat Nov 21 15:21:57 MST 2009
Geo,
Do you use any sealer on either side?
Bill
-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Geo Hahn
Sent: Saturday, November 21, 2009 1:31 PM
To: TR List
Subject: Re: [TR] Valve cover gasket TR3
I have always used the cork and have reused them through many many valve
adjustments. I note which way is forward & up and reinstall it with the
same orientation and, of course, do not over-tighten. Over time it has
taken on a shape to accomodate the edge of the valve cover making it molded
custom cork of a sort.
Note that there are different cork gaskets on the market -- looking at a
couple of spares hanging on the pegboard (one quite old & one left over from
a gasket set purchased mainly for the manifold and head
gaskets) I see that one (Payen?) is quite a bit thicker than the other.
I do not doubt that the silicone is a fine product -- just noting that the
cork can work fine for some.
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
More information about the Triumphs
mailing list