[TR] TR6 Windshield Frame Removal

Dave1massey at cs.com Dave1massey at cs.com
Mon Jul 13 05:56:46 MDT 2009


In a message dated 7/12/2009 12:15:04 PM Central Daylight Time, 
75TR6 at tr6.danielsonfamily.org writes: 
> Don't forget the three bolts/clamps on top of the dash at the bottom of 
> the
> windshield. As you noted the corner frame bolts that you've already 
> loosened
> are at an angel so you have to pull the windshield up at that same angel.
> However, those corners can get rusted in place to the point where some 
> guys
> have had to resort to a dremel cutting wheel to get it off.
> 

Bob, Bill, FWIW, the two windshields I pulled did not have any rust (and 
here in St. Louis that is remarkable) but I did have problems each time due to 
the fact that the windshields were installed whilst the paint was still 
soft.  I had to take the clamp loose and rotate it back and forth to break the 
paint bond.  Unfortunately, this involved removing the fresh air duct at the 
offending side to gain access.

One was a TR4 and the other was a TR6.  I reassembled both using grease (or 
antisieze) so the next guy won't have the problem.

Dave


More information about the Triumphs mailing list