[TR] [6pack] Crimping Bullet connectors
Bob Danielson
75TR6 at tr6.danielsonfamily.org
Sun Jan 11 16:26:02 MST 2009
Randall,
It is the British Wire tool and it does a 6-sided crimp..... ;-) ok.... It's
a hexagon. I hear you on the heat shrink tubing. I use a lot of it too.
Bob
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org
-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Randall
Sent: Sunday, January 11, 2009 4:23 PM
To: triumphs at autox.team.net
Subject: Re: [TR] [6pack] Crimping Bullet connectors
> Here's a pretty good picture of a bullet crimped with the tool
> http://tinyurl.com/98mxxy
Bob, is that the tool that British Wire sells? Looks like it does a 2-point
crimp, rather than hexagonal. I was under the impression that the 'proper'
tool did a hexagonal crimp. Much more expensive, but also much better.
Lacking a crimp tool, I just solder. And as you say, the original PVC
insulation generally melts for a short distance ... lots of my bullets have
a section of heat shrink to cover the melted area.
Randall
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as 75tr6 at tr6.danielsonfamily.org
http://www.team.net/archive
More information about the Triumphs
mailing list