[TR] TR2/3 ball joint installation problems
Randall
tr3driver at ca.rr.com
Mon Aug 31 10:54:21 MDT 2009
> Doesn't seem that the old spline groves help with
> this either.
Might be time to try a trial assembly off of the car, with just the front
arm & no spacer. Perhaps that will show you where the problem is. Kind of
sounds like perhaps your new ball joint is not properly made.
Using a press is going to be tricky, as the sides of the ball joint housing
are not at right angles to the shaft. You could possibly use a (stronger)
standard nut in place of the thin castellated one, but finding one at your
local hardware store might be difficult. ISTR those are something like 9/16
NF threads.
-- Randall
More information about the Triumphs
mailing list