[TR] TR4A Scuttle Vent Installation

[mgowen55 at hotmail.com]

Ben,
The actuator and spring must be released from the vent lid before the screws 
are accessible. When this is done, the lid can open all the way back.  The 
rod enters from the outside.
 A couple of pics are available at http://tinyurl.com/la2fch
HTH
Glenn



> Help!  I'm looking for hints on how to install the scuttle vent seal and 
> actuating rod on my TR4A.  With the seal in place, it seems impossible to 
> get the screws in.  Also, I can't find any orientation that allows the 
> actuating rod to be installed when after the vent is installed.  Does it 
> have to be installed before the vent is installed?  Does the end of the 
> rod enter from the "inside" or the "outside"?  (Appears to be from the 
> "inside" (from center of car going towards right fender).  Thanks for any 
> help, I've spent too much time on trial and error on this already so I'm 
> hoping someones BTDT.