[TR] TR3A Pinion Driving Flange

[Jerry Van Vlack]

They work very well, stops leaks from the timing cover seal too.
I also have one installed on the differential pinion seal.
Industry has used them for years with a lot of success.
JVV
----- Original Message ----- 
From: <WCA09 at aol.com>
To: <triumphs at autox.team.net>
Sent: Tuesday, April 07, 2009 8:46 AM
Subject: [TR] TR3A Pinion Driving Flange


> Hello, All,
>
> In replacing my rear axle pinion oil seal, I note that the flange itself
> shows considerable wear.  So much so that I doubt even a new seal will 
> actually
> 'seal' as it should.  I also note that Moss sells a Speedi-Sleeve  to 
> remedy
> this exact situation.  It apparently is pressed over the worn  area 
> providing a
> 'new sealable surface' (their claim).  Does anyone have  experience with 
> the
> Speedi-Sleeve?  Does it really work?
>
> BTW, I'm a relatively new participant in the list as I'm just putting  my 
> 3A
> back on the road after a 25+ year hiatus.  What a tremendous resource  it 
> is!!
> What you guys don't know about Triumphs isn't worth  knowing....
>
> Bill A.