[TR] TR6 suspension rebuild, where to stop the powder coating?
Dave1massey at cs.com
Dave1massey at cs.com
Wed Nov 26 12:22:41 MST 2008
In a message dated 11/26/2008 12:46:00 PM Central Standard Time,
dogzbody1 at yahoo.com writes:
> I was going to powder coat the front suspension pieces but am wondering if
> I need to tape over where the bushings go through. Should these be poly on
> metal or poly on powder coat on metal? Bare metal doesn't feel like the right
> answer but if it is I'd rather know before the powder goes on! Thanks for
> any light that you can shed on this mystery.
I just powder coated my TR3 control arms and fitted poly bushes with no
issues. The thickness is not of any significance as the poly bushings are a slight
interference fit anyway. The trunnion ends with bronze bushings (typical of
TR3's) are another matter.
>
> While here, what is the best treatment for the rear trailing arms? I was
> going to sandblast to de-stress and either clearcoat or paint. Can anyone
> recco a brand/type of paint that has worked for them?
When I did my TR6 I painted my trailing arms with Hammerite Silver. The
effect is similar to natural aluminum but with a slick surface that is easier to
keep clean. I think someone bought Hammerite (Rustoleum?) as I have not seen
it in my local Ace for quite a few years.
Dave
More information about the Triumphs
mailing list