[TR] Rubber steering coupling

Bob Danielson 75TR6 at tr6.danielsonfamily.org
Sun Mar 9 13:14:43 MST 2008


Bud,
I got my replacement rubber from Ted Schumacher and I just checked
it.....same as yours. Two countersunk holes on both sides. My original only
had the countersunk holes on 1 side. I've been told that the best way to put
it back on is to get 2 bolts in and then use a big old hose clamp to squeeze
it to get the other two holes to line up. My engine and tranny go back in
this week, so I'll get to the rubber coupling after that. Did you replace
your bushings too?


Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
http://tr6.danielsonfamily.org


-----Original Message-----
From: triumphs-bounces+75tr6=tr6.danielsonfamily.org at autox.team.net
[mailto:triumphs-bounces+75tr6=tr6.danielsonfamily.org at autox.team.net] On
Behalf Of Bob Rochlin
Sent: Sunday, March 09, 2008 2:38 PM
To: Triumphs
Subject: [TR] Rubber steering coupling

Hi Everyone,

            Im trying to fit a new rubber coupling to the steering shaft of
my TR6.  There are two problems.  One is that the replacement from TRF is
counter sunk for cap bolts on both sides of the coupling instead of one as
original, and the second is that the holes line up as about < inch too far
apart.  Has any one else had this difficulty, and does any one know a source
for this part that is made accurately?

            I knew things were going too smoothly




Bob Rochlin


72 TR6
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as 75tr6 at tr6.danielsonfamily.org

http://www.team.net/archive


More information about the Triumphs mailing list