[TR] Triumphs Digest, Vol 2, Issue 80
Don Spence
dkspence at telus.net
Wed Feb 20 10:09:18 MST 2008
Bob
Do you know if this is the same set=up on the TR4A? Same parts?
Thanks
Don
On 20-Feb-08, at 8:37 AM, triumphs-request at autox.team.net wrote:
> From: 75tr6 at tr6.danielsonfamily.org
> Date: February 19, 2008 5:34:16 PM MST (CA)
> To: <6pack at autox.team.net>
> To: <triumphs at autox.team.net>
> To: <6parts at charter.net>
> Subject: Re: [TR] throttle shaft bushings
>
>
> Al,
> I assume you're talking about the two shaft bearings that go
> through the bulkhead. If so, I just went through this with a
> certain degree of frustration. If you look closely at the bearings,
> you'll notice that one side is actually wider then the other side.
> By that I mean the hole opening that the shaft passes through has a
> tapered opening at one end. That means that the driver side bearing
> should be installed from inside the car and the passenger side from
> inside the engine bay. OR... you could do what I ended up
> doing.....I talked Art Lipp into making Delrin bearings that are a
> perfect fit and simple to install. You can see them here (http://
> tr6.danielsonfamily.org/AcceleratorShaft.htm). I tried using the
> bronze bearings that others suggested and didn't like them for a
> few reasons, including safety.
>
> Bob
More information about the Triumphs
mailing list