[TR] TR3 Steering box bearings

[Andrew Uprichard]

A couple of you (Bill B. and Paul D.) had asked about routing the gas line
for a TR3. Here are three pictures I took earlier today.  Andrew Uprichard

-----Original Message-----
From: triumphs-bounces+auprichard=comcast.net at autox.team.net
[mailto:triumphs-bounces+auprichard=comcast.net at autox.team.net] On Behalf Of
wbeech
Sent: Saturday, April 19, 2008 8:19 PM
To: 'Triumph List'
Subject: [TR] TR3 Steering box bearings

Pulled the end off the steering box today to check and adjust the end-float
and noticed that the outside bearing race was missing four(4) balls.
Hmmm.... it drove pretty good last summer. 
 
Before I shell out $80.to Moss for a new one, does anyone know if this item
is commonly available elsewhere at a reasonable cost? I mic'd the balls and
they are exactly 1/4".
 
Thx,
 
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as auprichard at comcast.net

http://www.team.net/archive

[demime 1.01d removed an attachment of type image/jpeg which had a name of Picture 001.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Picture 003.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Picture 002.jpg]