[TR] bushing/trunnion clearance
Randall
tr3driver at ca.rr.com
Thu Dec 13 21:47:07 MST 2007
> After pressing new bushings into the lower A-arms, (TR3) you
> are supposed to ream them to fit the trunnion. There was no
> clearance specified though, so how much do I have them
> reamed? I was thinking maybe .001" on a side for .002"
> total clearance, sound about right?
The clearance is built into the pin diameter ... just ream them to the
nominal size. 5/8" as I recall.
Randall
More information about the Triumphs
mailing list