[Tigers] Center grille badge

[D or G at sbc]

 Don't cut the badge, the cuts will show up from the front. If you glue/silicon it on, be careful what you use, some adhesives will mess up the badge paint. I would try a thin double-sided tape.
David

    On Tuesday, August 23, 2022 at 03:34:43 PM PDT, Andy Walker <awtiger at cox.net> wrote:  
 
 
Hey, everyone:

  

I went to replace my tired-looking center grille badge on my Mk1A with a repro badge, but the repro badge doesn’t have the inset side like the original to accept the stock retaining clips.  If I remove the clips, the repro badge fits perfectly into the hole but there is no means of retaining it there.

  

For those of you out there who have replaced these, how did you affix the repro badge?  I can see no way to attach it by using the stock clips without first modifying the sides of the badge to accept the clips.  Are we left with just using something like a silicone gasket product to hold it in place?

  

Thanks for any suggestions,

Andy Walker

Edmond, OK

B382001600LRXFE

TAC #740
_______________________________________________

tigers at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive

Unsubscribe: http://autox.team.net/mailman/options/tigers/orr4sale@sbcglobal.net


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20220824/fe5881b9/attachment-0001.htm>