[Tigers] side moulding clips

[Ron Fraser]

Thanks to all for the pictures.

Like I stated I have never seen the original parts, I was curious so this
was a good education.

I filed down some SS screws for this job.

 

These parts are listed in Imp line of cars - the parts are plastic. except
for the thread cutting fastener which is steel

 

Next question - how were the 6 parts assembled?

Anyone still have this assembly on their Tiger?  

Does anyone have a picture of the assembly?

 

Here is my best guess

 

7208008 is slid into the side moulding and inserted into the correct body
mounting hole

7208009 is pushed onto the shaft of 7208008 on the inside of the panel -
small diameter end 1st 

7208029 or 9035096 is gently threaded onto the shaft of 7208008 and gently
tightened to seal the bush and apply a pulling force on the moulding

 

Ron Fraser

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20191106/70706357/attachment.htm>