[Tigers] Oil Pressure Hose/Fitting

[Mark Rense]

I replaced one of these recently with a stainless version from Rick (SS). I
took out the speedo and got access to the gauge.

This also gives you the opportunity to practice your Batman impression by
hanging upside down and staring into darkness.

I take out the front seats before attempting any under-dash maneuvers.

On Fri, Oct 5, 2018 at 4:20 PM Richard Bruner via Tigers <
tigers at autox.team.net> wrote:

> The oil pressure hose on my car cracked near the block, with a predictable
> result.  I cut the cracked section off, and am trying to get the old,
> brittle hose back on the barbed fitting.  I've tried a lighter, a hair
> dryer and a heat gun so far, with no luck.  The hose blisters before
> getting hot enough to go on the fitting.
>
> Any suggestions?
>
> Richard Bruner_______________________________________________
>
> tigers at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers
>
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/mark44124@gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20181109/46352456/attachment.html>