[Tigers] Gas Cap Questions

[Gary Winblad]

Because the SS part is just the raw part, you have to assemble it with 
your old (internal) parts.
I would ask Rick.
But hope someone says how they did it.  I might need to do this sometime 
myself.
Gary


On 4/27/2018 6:03 AM, Jay Laifman via Tigers wrote:
> If you have a new one, why are you replacing the cork?
>
>> On Apr 26, 2018, at 12:29 PM, Joe Brown via Tigers <tigers at autox.team.net> wrote:
>>
>> Hi,
>>
>> I'm replacing my gas cap with a new one from Sunbeam Specialties and I see that I have to move over a little spring that goes under the push-button and the larger spring loaded metal piece with a cork washer that seals against the filler neck.  So I am looking for ideas about replacing that cork gasket.  It doesn't look like I can take the metal piece apart, so do I just take a razor and cut away the cork and cut a new piece of cork to fit?  Also, this spring loaded metal piece was held in to the cap with four rivets.  Should I just use self-tapping screws on the new cap?
>>
>> Thanks,
>> Joe Brown
>> _______________________________________________
>>
>> tigers at autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe: http://autox.team.net/mailman/options/tigers/jay.laifman@gmail.com
>>
>>
> _______________________________________________
>
> tigers at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/garywinblad@comcast.net
>
>