[Tigers] Here I go again...

[Ron Fraser]

Mayf

 

1                     Sunbeam Specialties or other Sunbeam vendors

2                     Ebay unless someone has one on hand - Alpine have them
too

3                     These are Tiger specific parts - Ebay - a pipe fitter
shop might be able to make the copper one

4                     Sunbeam Specialties or other Sunbeam vendors

5                     Classic Tube has them in stainless steel - I took some
5/16 tube to my local garage and had him put that bubble in the tube with
his tool - I then cut the extra length off -  then bent the line from the
carb to the filter.  Do you need the line from the filter to the carb or the
lower line that runs along the engine which has 2 of those pesky barbs - the
barb at the rear of the engine block is shallower so it fits through the
grommet of that rear bracket.

 

The voltage stabilizer using the LM317 is listed @ Tigersunited.com in the
tech tips section by Cullen Bennett I believe.

 

Ron Fraser

 

From: Tigers [mailto:tigers-bounces at autox.team.net] On Behalf Of Larry
Mayfield via Tigers
Sent: Tuesday, September 20, 2016 7:12 PM
To: Tiger List <tigers at autox.team.net>
Subject: [Tigers] Here I go again...

 

Ok some basic acquisition of parts questions: 

1.    Engine temp sensor

2.    Map light assembly that is installed over the glove box

3.    Ahh, and now the hard ones. that small cast iron T fitting in the
heater line that the temp gauge sensor screws into and feeds hot water to
the carb heater spacer. And the copper one, a dual size T fitting,  that
joins the carb heater water back with the cabin heater water and puts it
back into the motor.  I am sure I have both of these somewhere in my 'pile'
but where to start looking. I know I have a replacement carb spacer.   

4.    The girling or suitable rebuild kist for the clutch slave and clutch
master cylinders. CAT is out of them. Vicky Brit has them but alternates are
good to have. Pegasus has them once you figure out what the bore diameters
are.  

5.    Another one - the fuel line that comes from the rubber hose joint that
lives underneath the generator and feeds the filter at the carb. I could
make one but need something with a barb on it to feel completely
comfortable. Source of tube? I know I can buy 5/16 tube at the local parts
places but need that pesky brab on the end. 

 

Note: I found the voltage stabilizer for the MG in VB. Looks exactly like
what I have. Cost is $8.95. Waiting for reply from Tom Hall on stabilizer.
And I have a schematic for one built some time ago. It has a pot that allows
for adjustment of volts to correct small discrepancies. Uses LM317 device. I
may have that, need to look.  

 

Any help out there on 1 - 5? Need sources and links or email addy so I can
contact the supplier.

 

mayf

 

_________________________
drmayf
Worlds Fastest Sunbeam, period.
204.913 mph flying mile
210.779 mph exit (not top)  speed

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20160920/ab6b254b/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image002.jpg
Type: image/jpeg
Size: 959 bytes
Desc: not available
URL: <http://autox.team.net/pipermail/tigers/attachments/20160920/ab6b254b/attachment-0001.jpg>