[Tigers] Dash Pieces

[Cars]

The temp and gas gauges work off a voltage stabilizer. Have you checked that piece?

Lynn

Sent from my mobile device

> On Sep 18, 2016, at 5:57 AM, Ron Fraser via Tigers <tigers at autox.team.net> wrote:
> 
> <image002.jpg>
> Mayf
>                 Wire diagram is available in Shop Manual @ Tigersunited.com
> http://www.tigersunited.com/resources/wsm/wsmN35.asp
>  
> Dash lights have a daisy chain ground wire.   I have a problem with the panel light switch not always working so I leave it in the ON position so the dash lights turn on with the Light switch.
>  
> Light switch is powered from B post of the generator voltage regulator.  Your headlights work so that switch is working.  There is a Red wire from Light switch to Panel switch, then a Red/White wire to dash lights – those need to be checked.
>  
> Ron Fraser
>  
> From: Tigers [mailto:tigers-bounces at autox.team.net] On Behalf Of Larry Mayfield via Tigers
> Sent: Saturday, September 17, 2016 10:06 PM
> To: Tiger List <tigers at autox.team.net>
> Subject: [Tigers] Dash Pieces
>  
> Ok, I am replacing and adding a couple of dash switches to my car.  The pieces I need are the chrome screw on switch bezel for use on the wood dash.  Is there a source for such?  I have the switches but sadly they do not come with them. 
>  
> And I am having the dickens of a time with the instruments: mostly with the dash lights. I know grounds are the typical source or cause of the problems and I have been attacking that as best I can.  Also there does not seem to be power to that circuit, even when I turn the lights on and the panel switch as well.  I replaced the fuse block and that did help. More voltage. Was pretty corroded. New one has a spiffy cover and I applied dielectric grease as well.  The wipers work, the horn honks the heater motor runs, have oil pressure, but no dash light or fuel level or temp. Also purchased a brake light switch as well. Turn signals work as does the green indicator light on the dash. Head lights ( high and low beams), turn signals and stop light all work. Part of the issue is size 100 hands (big) in a size 3 under dash.  So I am going to keep after it.  Was there an wiring change in the MK1 production run? The wiring on my gas and temp gages does not look like the schematic.  If I look at the back side of the fuel gage and temp gage what wire goes where?
>  
> Some remote help needed here… at least some advice or comment.
>  
> mayf
> _________________________
> drmayf
> Worlds Fastest Sunbeam, period.
> 204.913 mph flying mile
> 210.779 mph exit (not top)  speed
>  
> _______________________________________________
> 
> tigers at autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/cars@wt-inc.com
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20160918/e538bf15/attachment-0001.html>