[Tigers] Tiger oil capacity w/non-stock filter

[Ron Fraser]

Dave 
 
    It looks like I need to investigate the dip stick part further.
 
The dip stick and dip stick tube should be a matched pair.
 
Parts List 6601334
1224808    Oil Level indicator    NOTE - this is a Rootes part # only
6100734    Oil Level indicator    NOTE - this is a Rootes part # for a Ford
part
C4JZ-6750-A seems to be the Ford part #
 
6100489    C2OZ-6754-A    Tube - Oil level indicator
 
Ford Master Parts Catalog - listed for the 260 engine
C3OZ-6750-B    22.48" shield to full, 23.32" shield to Add, 24.44" shield to
tip
C2OZ-6754-A    Tube
 
This appears to be the correct dip stick and tube combination for the Tiger.
 
Maybe 1224808 is indicated because Rootes had to modify the dip stick.  The
long handle had to be bent to clear the hood.
I'm sure this prompted Rootes to have Ford correct this issue with a new
part - possibly the C4JZ-6750-A part - the "J" in this part # indicates a
Ford Industrial Group supplied part.
 
The later Tiger dip stick has the handle loop tighter to the shield with
only a slight bend.
 
The C3OZ-B and C2OZ-A parts are being reproduced by Scott Drake.
 
Ron Fraser

-----Original Message-----
From: Dave Barakat [mailto:dave.barakat at icloud.com] 
Sent: Monday, October 05, 2015 2:20 AM
To: rfraser at bluefrog.com
Cc: Andy Walker; tigers at Autox.Team.Net
Subject: Re: [Tigers] Tiger oil capacity w/non-stock filter


Ron...thanks.this is so helpful and I will measure the stick and tube
against David's spec. The tube and stick were obtained from SS as  "dipstick
for generator cars" (TM50/TM54), but no other part number given. 





On Oct 4, 2015, at 6:43 PM, Ron Fraser <rfraser at bluefrog.com> wrote:

Dave
    It is very possible you do not have the original dip stick.  I'm not
sure I have the original in my engine either.
 
Parts List 6601334
1224808    Oil Level indicator    NOTE - this is a Rootes part # only
6100734    Oil Level indicator    NOTE - this is a Rootes part # for a Ford
part
C4JZ-6750-A seems to be the Ford part #
There is no indication about when this part change occurred.
 
Here is an email from David Franchi - 8/12/2004 with some measurements.

The original dip stick & tube measurements are:
Stick - 24 7/16" from the tip to the inside top of the "bell" cover/dust
guard. 
Oil "add" mark 1 1/8" from tip, oil "full" mark 2" from tip.
--
Tube - 15 15/16" overall. 14 3/4" from the top of the "stop/seating ring"
(were it goes into the timing gear cover) to the top of the tube. 7 5/16"
from the top of the tube to the center of the "mounting wing".
--
With the stick installed in the tube, the tip of the stick protrudes 9 1/2"
out of the end of the tube. (measured from the tip of the stick to the
bottom of the tube "stop/seating ring") 
David Franchi
Ron Fraser



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20151005/b7ac2eaa/attachment.html>