[Tigers] motor mount reinforcement
CoolVT at aol.com
CoolVT at aol.com
Sat Apr 4 20:08:52 MDT 2015
I used method #1 and no problems after 5 years. But, the car hasn't been
used on the strip or track either.
In a message dated 4/4/2015 9:07:52 P.M. Eastern Daylight Time,
tigers at autox.team.net writes:
Just checking to see if anyone has drilled through and bolted their motor
mounts to prevent separation and the accompanying damage to their fan
shroud and hood. If so what method did you use. 1) drilling through the plates,
countersinking the heads of the grade 8 bolts and simply a washer and
nylock nut clamped tight on the backside or 2) a similar procedure differing
only in that you would drill a slightly larger hole on the exit side and under
the clamping washer place a neoprene washer to isolate the bolt, washer,
and nut slightly from the top plate to minimize vibration issues. Is this
over thinking the problem, that is, is the vibration caused by the through
bolts even that big of an issue? Thanks to all in advance.-Brad
_______________________________________________
tigers at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/coolvt@aol.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20150404/41770802/attachment.html>
More information about the Tigers
mailing list