[Tigers] Exhaust Manifold question

[Ron Fraser]

George
	See Tigersunited for a picture of the exhaust manifold and tubes;
Section AF, plate D.
http://www.tigersunited.com/resources/parts_rs260/FactParts.asp

Both tubes should pull out of the manifold but they maybe rusted in place.
There are also a couple other parts listed for this heat riser but I have
never pulled one of them that far apart.

If one or both tubes will not move; try heating the manifold and see if they
will turn a little then you should be able to work them out.   If you can't
get them to turn; heat them then put some ATF at the tube/ manifold joint
and try to turn it out of the manifold.   If all fails; cut them  off and
drill out the holes; those tubes are available or you can make them.

If you put any lubricant on the manifold be sure to clean well before
sending them out for coating.

Ron Fraser



-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of George Re
Sent: Wednesday, June 22, 2011 10:33 AM
To: Tigers
Subject: [Tigers] Exhaust Manifold question


I am just about to send my manifolds out for coating but have run into a
small problem. There are 2 tubes on the Right manifold one goes to the choke
and one goes to the bottom of the air cleaner HOW do you remove the tube
(the one that goes to the bottom of the cleaner) from the manifold? I have
no idea and can not find any info on it. Thanks in advance

George Re
_______________________________________________

tigers at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.biz


No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.449 / Virus Database: 271.1.1/3717 - Release Date: 06/22/11
06:34:00