[Tigers] Wheel stud replacement

[Owain Lloyd]

when i snapped all four studs in morocco, i cut a very small v shaped notch
in the axle flange with a hack saw.  then i cut a little flat off one side
of the head of each of the new suds and there was enough room to get them
in.  took about 15 minutes from the start to having the wheel back on.  to
remove the old ones just cut them down and bang them out (or wait until they
all sheer off as i did!).

On Fri, May 7, 2010 at 3:55 PM, Randy Zimmermann <zimme008 at yahoo.com> wrote:

> I need to replace the wheel studs on my rear wheels.  Can this be done
> without
> pulling the hubs off?
>
> Appreciate any guidance or advice.  Thanks.
>
> Randy Z
> Duluth, MN
> 67 MkIa
> _______________________________________________
> Tigers at autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/tigers/owain.lloyd@gmail.com