[Tigers] Fw: Panel lights switch questions
Tony Somebody
achd73 at yahoo.com
Thu Aug 27 22:31:31 MDT 2009
Jim- Im not sure what wiring diagram you are using but I highly recommend
buying the laminated one from CAT. It has Mk1 on one side and Mk1A on the
other. Im thinking about a spare to store under the passenger seat, since its
water proof. It shows the red w/ a white stripe illuminating the gauge lights
thru out the system. It connects to lug 8 not 1. If memory serves that switch
is the only one installed upside down and if your switch is up side down, then
lug 8 would appear to be lug #1. The way to tell what lugs are 1 and 2 and 7
and 8 is use your meter- the two lugs w/ continuity are 1 and 2. 7&8 have no
continuity and that also decides top(1&2) vs bottom (7&8). If memory serves
the gauge light switch was installed from the factory up side down BUT an
original owner with switches in original position would have to confirm that.
My second Mk1A was that way and Im pretty sure no wires or switches had been
changed. Someone who knows for sure want to
"speak up"concerning the gauge lights switch being opposite of all other
switches????
TtT
--- On Thu, 8/27/09, Ron Fraser <rfraser at bluefrog.com> wrote:
> From: Ron Fraser <rfraser at bluefrog.com>
> Subject: Re: [Tigers] Fw: Panel lights switch questions
> To: "'James Pickard'" <geowiz.sgy at cox.net>, tigers at autox.team.net
> Date: Thursday, August 27, 2009, 10:43 PM
> Jim
> You can gently pry these switches apart,
> clean the contacts and put
> back together.
>
> The wire diagram shows the red wire, power, to terminal #4
> and a red/ white
> wire, gage illumination, at #8.
>
> Do you have a second R/W wire at #1?
>
> Ron Fraser
>
> -----Original Message-----
> From: tigers-bounces at autox.team.net
> [mailto:tigers-bounces at autox.team.net]
> On Behalf Of James Pickard
> Sent: Thursday, August 27, 2009 10:37 PM
> To: tigers at autox.team.net
> Subject: [Tigers] Fw: Panel lights switch questions
>
>
> My panel lights switch is bad. It only works when it
> is half way between
> the middle and bottom position. But I have two
> questions. I know up is
> off, but I've forgotten what the difference is between the
> middle and down
> position. Second question concerns the wiring. My
> switch has a red/white
> wire attached to terminal 1 that disappears into the wiring
> harness. The
> wiring diagram shows no such wire. Anybody else have
> this? If so, what is
> it for? Thanks.
>
> Jim Pickard
More information about the Tigers
mailing list