[Spridgets] just a double check.....

[Mark Haynes]

Thanks Kevin,
That's what made sense, but since I'm questioning everything that I've
done, confirmation helps.
Thanks😁

On Mon, Jul 22, 2024, 8:24 AM Kevin Valentine <kevinv1275 at gmail.com> wrote:

> Mark,
>
> Yes, the ends where the bolts go thru the clamp are supposed to be flush
> with the block and the center section of the clamp where the dizzy goes
> thru is slightly raised.
>
> Kevin V.
> Tuscarora, Pa
>
> On Mon, Jul 22, 2024 at 9:17 AM Mark Haynes via Spridgets <
> spridgets at autox.team.net> wrote:
>
>> I still need to turn my dizzy clamp plate around so that the clamp bolt
>> is on top and visible, so I thought that I'd check that since the end
>> sections where its bolted to the block are not planar to the clamp portion,
>> that they are to be assembled flush to the block and the clamp portionis
>> raised. This is how I have it assembled, just a check that it should be
>> this way and I'm not reducing the the engagement with the drive gear.
>> Thanks, still looking for the no-start cause,
>> Mark Haynes
>> It only goes one way- Pay It Forward
>> ------------------------
>>
>> spridgets at autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation: $12.75
>>
>> Archive: http://www.team.net/pipermail/spridgets
>> http://autox.team.net/archive
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/spridgets/kevinv1275@gmail.com
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20240722/14a2d1ac/attachment.htm>