[Spridgets] Need help with my 67 Sprite clutch

[Phil Sarikas]

Oh my.  I think so, but now that you ask, I will have to check.   I can, pry open the inspection port and put a small camera in there this week to confirm. I will start that Tuesday night

Thanks, Phil

On Jul 5, 2021, at 12:35 PM, Rick Fisk <refisk at chartermi.net> wrote:


Hi Phil,

Are you sure you replaced the throwout bearing with the correct unit?  There are three different throwout bearings available for the A-series engine.  Photo below from Gerard's Garage website shows the difference.

Rick

<image0.jpeg>


On Jul 5, 2021, at 3:19 PM, Phil Sarikas via Spridgets <spridgets at autox.team.net> wrote:



I need the help of this group to get my clutch working as well as can be.  The car is any early 67 sprite with a 1275 and the standard ribcage transmission.  At this point, everything in the hydraulic system has been replaced over the 20 years I have owned the car.


Over the winter/spring, I had the engine out and did some work to reduce the overall oil leaks and did replace the needle bearings in the transmission, and a new throwout bearing but nothing that opened up the clutch hydraulic system.


Put it all back together and went for a drive and the clutch was clearly not working correctly, I could get it to shift but it often required me to pump the clutch several times to get it to shift correctly and could only get it into reverse if I went to the path of turning off the motor and restarting it in reverse.  Not a place I can stay.  I bled it as completely as I could with my EZ-Bleed and tried it again.  I wish I could say it was better, but no real change.


I have pulled the slave cylinder, no signs of leaks, and no real signs of pitting in the cylinder, and I was going to rebuild it as well as the master but turns that my box of parts has 2 seal kits for the master cylinder, and none for the slave cylinder.  As I wait for the local shop to open on Tuesday, I looked around on this site and others, and it seems that some have successfully applied the smaller cylinder from a 1098 on the 1275, same transmission, bolts up but needs a shorter pin, but how does the hydraulic part work?  There is no equivalent rubber pipe on the earlier cars?  I like the rubber connection so I would need some work of an adapter to cover from what appears to be a 7/16 fine thread (20?) on the pipe (adaptor would need to be female) To a 3/8 fine (24?) On the 1098 slave cylinder (adaptor would need to be male).  Is there such an adapter off the shelf?


Is there a downside to the smaller diameter slave cylinder other than perhaps a bit more force to move the pedal?  I did check with a camera, I am getting movement as soon as the clutch pedal is depressed, just not enough movement to fully disengage the engine from the transmission.


Open to any and all input!


Thanks, Phil

Thanks, Phil
------------------------

spridgets at autox.team.net

Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75

Archive: http://www.team.net/pipermail/spridgets  http://autox.team.net/archive

Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20210706/3ca97dad/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image0.jpeg
Type: image/jpeg
Size: 26889 bytes
Desc: image0.jpeg
URL: <http://autox.team.net/pipermail/spridgets/attachments/20210706/3ca97dad/attachment.jpeg>