[Spridgets] Sprite Mirror bracket

[Allen Hefner]

Daniel,

It looks like you would have enough room to fit a cup holder on the
trailing end of the bracket! I found that there isn't enough room inside
the car for one.

Allen Hefner
Norristown, PA
Sun City Center, FL

*Current:*
2016 Subaru outback somewhere
2006 Chebbie
*Former:*
1963 Sunbeam Alpine Series III
1967 Triumph TR4A IRS
1964 VW Type I
1967 VW Type II
1967 Rover 2000TC
1977 MG Midget (Sniff!)


On Sat, Nov 2, 2019 at 2:45 PM Weslake1330 via Spridgets <
spridgets at autox.team.net> wrote:

> Hi List,
>
> I've just finished making my first mirror bracket.  Well actually it's the
> second because I abandoned the first one part finished as it wasn't quite
> right.  I'm pleased with the end result but I'll be making another one as
> this one isn't quite perfect.  Yep, it does stick out a bit from the
> bodywork (just under 3 inches) but its supposed to because being close to
> the car's bodywork makes it much less aerodynamic (air sees a bigger bulge
> than the actual mirror).  Very wet here so it may be a week before it gets
> road tested - the worst that can happen is that it vibrates and I need to
> use thicker aluminum sheet (this was 1.2mm) or stainless steel sheet.
>
> Photos attached.
>
> Regards
>
> ------------------------
>
> spridgets at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
>
> Archive: http://www.team.net/pipermail/spridgets
> http://autox.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/lbc77mg@gmail.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20191105/22581d3d/attachment.htm>