[Spridgets] Work bench surface

[Rick Fisk]

Most stainless sheets I've seen are pretty tough.  18 gauge stainless should be good.

Sent from my keyboard

> On Apr 9, 2016, at 9:37 PM, Trevor Jessie via Spridgets <spridgets at autox.team.net> wrote:
> 
> I have a small workbench in the corner of my home garage that is 23" x 52".
> The bench top is actually just made from scrap 2x4's and it has always had a sheet of aluminum on it for a surface.  The aluminum was too thin and has seen better days so I want to replace it with stainless steel.  I've been watching Craigslist for an old kitchen prep table but they all seem to bring good money.
> 
> The question:  If I were to just go out and buy a sheet of new stainless for the bench surface ... what gauge would be sufficient?
> 
> Alternate question:  Any other suggestions for something to use as a bench top surface?
> 
> -Trevor
> 
> 	Virus-free. www.avast.com
> ------------------------
> 
> spridgets at autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> 
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20160410/1b0ad432/attachment.html>