[Spridgets] Facet Pump Installation

[WeslakeMonza1330 at aol.com]

I would get AN threaded fittings from _www.aircraftspruce.com_ 
(http://www.aircraftspruce.com)   I'd expect  (without checking you need an NPT at the 
end that screws into the pump that has  -6JIC at the other end.  Then I'd get 
a 90 degree or straight threaded  fitting that is -6 JIC at one end and a 
barbed fitting for rubber hose at the  other end.
 
Variations on this theme would be a small dash size on the adaptor and thus 
 the 90 degree etc.
 
 
In a message dated 12/08/2013 16:03:17 GMT Daylight Time,  
bertshirey at zoominternet.net writes:

The  Facet pump has 5/16" fittings. I should know, but this looks larger
than  what`s there. Before I cut line and end up replacing the whole  
business,
what is the size of the stock solid fuel pipe on the Bugeye? If  5/16" is 
too
large, is there a way to adapt to a smaller  pipe?