[Spridgets] Seat rail question 62 Sprite

[Linda Grunthaner]

I received a message saying that being the passengers seat doesn't adjust I
should have 1 rail each side with the board under (I have that wooden board)
the outside strip for the passengers seat. Which could be the reason why I
can't find the other 2 rails.
Lin

On Mon, Oct 24, 2011 at 12:53 PM, CosmicMag1380 <cosmicmag1380 at gmail.com>wrote:

> On Mon, Oct 24, 2011 at 6:24 AM, Linda Grunthaner <grunthaner at gmail.com>
> wrote:
> Before I remove the drivers seat to get my answer do my seats have
> another rail sandwitched between the floor rail to the seat?
> ---------------------------------------------------------------------------
> There are 4 rails for each seat. Two mount to the seat frame and two
> mount to the floor. The two that mount to the floor have studs in  one
> end. If the studs are missing, it is usually because they broke while
> being removed and you can drill them out. Just replace with a bolt.
> IIRC, the stud goes to the rear of the seat.
>
> Look closely at the seat rails that are on your driver's side for the
> correct orientation!!! If you try to install facing the wrong side,
> they won't line up... Bolt the slide rail to the seat frame, slide the
> mounting rail into place, and carefully lower the whole assembly into
> place and bolt up!
>
>
> --
> Kent
> 1960 Bugeye
> 1983 Garage full of spridget parts!
> 2010 Arrow shed full of excess spridget parts!!!