[Spridgets] Rear Axle Housing

[Bob Spruck]

> From actual measurement of two bare rear ends:
>
>REAR AXLE ASSEMBLY
>
>TYPE DIMENSION MEASUREMENT POINTS
>
>STEEL WHEEL DIFF ASSY
>Over all width*         41 3/4" (41.75")        From inside of brake 
>backing plate flange to inside of opposite flange
>Left Hand Brake rod     14 3/4" (14.75")        From center to 
>center of clevis pin holes
>Right Hand Brake Rod    26 1/4" (26.25")        From center to 
>center of clevis pin holes
>
>WIRE WHEEL DIFF ASSY
>Over all width*                 40 3/4" (40.75")        From inside 
>of brake backing plate flange to inside of opposite flange
>Left Hand Brake rod             14 " (14.00")   From center to 
>center of clevis pin holes
>Right Hand Brake Rod            26 " (26.00")   From center to 
>center of clevis pin holes
>
>   *Wire wheel assembly is 1" narrower than steel wheel assy
>   *Wire wheel and steel wheel rear hubs are same except for stud length




Bob Spruck
MGMaven
Sharpsburg, GA
67 Midget Vintage Racer
72 Midget Street and Show
6 parts/project cars