[Spridgets] Removing a cut-off bolt.... Ideas??

[corvallis at peoplepc.com]

If you have a reversible drill, there are left-hand drill bits available. By
drilling a pilot hole you can really get a grip in it with a larger
left-hand drill bit. ..bill
===============================================================
On Jun 28, 2008, at 1:51 PM, Dave G. wrote:

> My beast is a '65 Sprite.
> On the drivers side of the tunnel is/was a place for the seat belt  
> securing bolt.
> One of the DPO's has cut this bolt off (!) leaving less than 1/8"  
> of bolt
> showing... and then painted over it...
> I would like to solicit ideas on how to remove this sawn off bolt  
> so I can use the
> built in threaded part to install some proper seat belts...
> I have no power tools --- only hand tools.
_______________________________________________