[Spridgets] Sleeving master/brake cylinders - Stainless vs. Brass

[Robert Duquette]

No, I hadn't as it wasn't really my question ... but I tried it and look 
what came up on sierra's site?

http://www.brakecylinder.com/sleeve2.htm#stainless


----Original Message Follows----
From: <corvallis at peoplepc.com>
To: "'Robert Duquette'" <robertduquette at sympatico.ca>
Subject: RE: [Spridgets] Sleeving master/brake cylinders - Stainless vs. 
Brass
Date: Thu, 19 Jun 2008 06:27:23 -0700

Have you Googled the subject? There are other cars out there that have had
experience with this issue. ...bill in oregon
===========================================================================

----Original Message Follows----
From: "Dean Hedin" <dlh2001 at comcast.net>

I am sure that the brass the outfits are using is durable but I can still
imagine corrosion and wear in brass after a couple years, especially in the
master
cylinder.

What I can't figure is why doesn't everybody use stainless? The material
cost is not the issue here.
_______________________________________________