[Spridgets] Can't get new engine to fire cont.

[Ron Soave]

Switch plugs 1 and 4, 2 and 3 to tell quickly.


--- On Sun, 8/10/08, Lester <oldsaabguy at comcast.net> wrote:

> From: Lester <oldsaabguy at comcast.net>
> Subject: Re: [Spridgets] Can't get new engine to fire cont.
> To: kidjoevid at yahoo.com, "Spridgets List" <spridgets at autox.team.net>
> Date: Sunday, August 10, 2008, 12:23 PM
> Remember first reply.. dizzy is 180 degrees out... guess
> what, dizzy  
> is 180 degrees out..
> 
> Lester
> 
> 
> On Aug 10, 2008, at 9:31 AM, Joe Lansing wrote:
> 
> > OK - I tried using a plug wire straight to #1 from
> coil. It did not  
> > fire. I pulled the plug and turned it over, and there
> was spark at  
> > the gap. I'll try a new coil. But one question -
> could my engine  
> > builder have re-assembled with the cam so far out of
> time with  
> > everything that it won't run? I'm pretty sure
> it isn't, as when #1  
> > is TDC, both valves for #1 are open, distributor drive
> shaft slot is  
> > at 2:00.
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
> 
> You are subscribed as soavero at yahoo.com
> 
> http://www.team.net/archive
> 
> http://autox.team.net/mailman/listinfo/spridgets