[Spridgets] Carbs and door hinge screws

Duncan Sinclair duncan at pondhop.com
Tue Apr 22 19:49:47 MDT 2008

The door hinge screws are actually oizi-drive and not Phillips so hard to
find here in the US.
If you are not worried about being totally original you can get Phillips
ones here www.mcmaster.com


-----Original Message-----
From: spridgets-bounces+duncan=pondhop.com at autox.team.net
[mailto:spridgets-bounces+duncan=pondhop.com at autox.team.net] On Behalf Of
lindalnhvt at nhvt.net
Sent: Tuesday, April 22, 2008 8:23 PM
To: spridgets at autox.team.net
Subject: [Spridgets] Carbs and door hinge screws

I'm looking for a souce for the door hinge phillips screws that secure the
hinge to the A post. I can find the thread, but only in a hex head bolt.
The buguye doors need a phillips screw.

Next --- Where do I look for step by step directions for adjusting the
carbs. I got the 66 out of storage yesterday and after some effort, got it
started and it ran pretty well on the 15 minute ride home.  I took it out
again last night when the engine was still warm and it started right away,
with a bit of sputtering, but not too much. I tried to start it this
morning when it was 37 degrees and again tonight when it was 55 degrees,
but it won't catch, or even start to catch, when I turn it over. Air
filters are off, pistons move freely and it smells like it's getting fuel.
I need help to get it running and to stay running.
Dick B. in NH
You are subscribed as duncan at pondhop.com



No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 269.23.3/1391 - Release Date: 4/22/2008
8:15 AM

More information about the Spridgets mailing list