[Spridgets] rocker shaft and head studs..correct procedure
Andy Webster
a_d_webster at yahoo.com.au
Mon Oct 22 01:06:35 MDT 2007
Ok!
So the 1275 is in and it runs... it sounds a bit tappetty , so I am going to swap the rocker assembly with the one on my 1098.
Both are pressed steel type of rockers.
What is acceptable procedure for this?
Should I undo all of the head studs, in the reverse order to that which I tightened them...then change the rockers? do I need to fit a new head gasket?
OR
Should i just undo the studs that hold the rockers on, then change rockers and refit the nuts and retension?
cheers
Andy
---------------------------------
Sick of deleting your inbox? Yahoo!7 Mail has free unlimited storage. Get it now.
More information about the Spridgets
mailing list