[Shop-talk] cove (or 'dish') style cut on a piece of wood.

[Eric Russell]

Does it need to be dished on the bottom or can it be rounded around the 
sides and flat on the bottom?

If the latter, consider a cove cutting router bit. Some have bearings on 
the top so you can use a pattern jig attached to your work piece. Make 
the cut in stages - increasing the depth with each pass.

https://www.amazon.com/CMT-851-502-11B-Bearing-Diameter-Carbide-Tipped/dp/B000P4O5ZC 


Eric Russell
Mebane, NC

On 12/13/2018 1:31 PM, eric--- via Shop-talk wrote:
> I'm making a piece of furniture that needs to have a rounded 'dish' 
> cut into it.  Like a cove cut on a board, but just in a circle.  Think 
> of a change plate where there is a bowl cutout on a board. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/shop-talk/attachments/20181213/4cca9019/attachment.html>