[Shop-talk] Bosch drill switch wire removal

[Steven Trovato]

I need to replace the power cord on my Bosch 1021VSR drill.  I know 
that the wires can be attached to the switch in different 
ways.  There can be screws or the wires can "push in."  In that case, 
you would stick something into a release hole to free the wire.  On 
my switch, I am not seeing any screws and I don't see anything else 
to release the wires.  Do any of you know how to get the wires out of 
this switch?  Sounds like it should be a simple enough job, 
right?  The end of the switch was covered with a sticky black foam 
piece that I removed.  There is a slot on the edge of the switch next 
to the one wire.  It isn't really where I'd expect a release to be, 
and I haven't been able to release anything from there so far.  I 
would think there would have to be one for each wire if that was the 
release.  Any ideas? Thanks.

-Steve


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus