[Oletrucks] 3 speed overdrive conversion

mark at noakes.com mark at noakes.com
Sun Dec 11 14:03:22 MST 2011


I happen to have the 3-speed out of my 58 Suburban stored next to the 
3-speed OD I plan to put back into it. As far as I can tell, they are 
identical in length, 22 inches from trans-to-bellhousing mount to end of 
tail piece plus 1/2 inch out the back for the splines on the shaft.

Mark N
58 Chevy Suburban, 2wd, V8 3-speed OD if I ever get it finished
58 GMC 1/2 ton big back window short bed wideside, NAPCO 4wd, 4-speed, 
270 6, orig power steering

On 12/11/11 3:29 PM, Robert Swanson wrote:
> 	I have a 3 spd overdrive from a 1/2 ton (55-59), and it looks to be the same
> length as the standard transmission.  I don't have a regular non overdrive
> tranny to confirm the measurements.  I have a parts book and will look to see
> if the driveshaft for the overdrive is a different part number.
> 	If someone does have the length of the talishaft for the non overdrive
> transmission, it will be easy for me to confirm whether or not the driveshaft
> length will have to change.  I don't think it does.
> 	If you don't have the parts for the column shift, I would just use a floor
> shift.  Old column shifters can be a pain to get set up properly.
> 	The transmission freewheels when it is in the overdrive mode.
> Bob


More information about the Oletrucks mailing list